Zenith Dare to Tear Question

[vodkalodka]

Ok so its not the obvious should I or shouldn't I . I think that' been established. But for those that have open them up, have you found a way to "save" the tear card easily? Is there a good spot to cut with an exacto and not cut the under card?

Would love to hear from a few people with there different ways.

Thanx
Ron

 

[pens1fan]

Check out this link from Panini

http://paniniamerica.wordpress.com/...ere-video-2010-11-zenith-hockey-with-contest/

it has of video of Tracy Hackler and Clint Hall(brand manger for Zenith) the viedo shows exactly where you should cut.

 

[frankiefives]

At the back of the card, there is a black line 3/4 of the way down. I cut mine right there. Hardly noticeable at all

 

[chadsexington]

I like the way shown here where dude was busting for Tony (OneGoal2010)

http://www.youtube.com/watch?v=PUlVSUKcCNM

"How the **** do you open these things?"
*RIIIIIIIIIIIIIIIIIIP*
"Oh look a card inside"

 

[Raffi31]

I like the way shown here where dude was busting for Tony (OneGoal2010)

http://www.youtube.com/watch?v=PUlVSUKcCNM

"How the **** do you open these things?"
*RIIIIIIIIIIIIIIIIIIP*
"Oh look a card inside"

Hahahaha thanks for posting that. Hilarious!

 

[hederman]

I'm waiting for someone to rip the insert card in half trying to bust it out.

 

[DougLaurieSports]

I brought in a box of the old Zenith a few years ago and before I could stop him, a customer cut right through the middle of the 5x7 card. He managed to slice the top third off a Lecavalier RC.

I've been using a boxcutter just below that black line and it's worked fine -- just be careful taking the smaller card out or you'll ding the corners.

Still love this idea, though.

 

[Bossy22]

I just wish there was one a pack instead of one a box.

 

[gratzi]

The Dare to Tear are jumbo cards right? Is that for all DTT cards, even the epix?

 

[vodkalodka]

I believe everything marked on the checklist in the box DTT are from the Rip Cards.

Thanx for the few different of opinions. I do love the video. Saw my LCS owner do the same too.

I've found that if you cut a vertical along the right side between the middle section where the writing is and black line (in the white blank space) it gives you a good size slit to pull the card out without dinging a corner. But then again I got 4 Epix base so maybe I need to swith my method for luck.